Puhui Electric Technology Co. Ltd

Model Number: BGA IRDA Welder T-870A-1 Brand Name: Puhui Key Specifications/Special Features: Instructions:First step:According to PCB big and small, reconciliationPCB plate space between the unsolder BGA have to face top red light, let facula cover CMOS chipReconciliation light and sensor high in order to keep from CMOS chip to light about 20mmSensor's warm just touch CMOS chip or side so that keep warm exactly

Will be used syringes to inject liquid flux demolition welding at the bottom of the chip

Welding can also help prevent loss pad

Second step:

• The warm-up plate's warm up sensing head, put on the PCB's weld plate hole or sheet copper, not on the board which is below the top Al stint, because affect warm

The third step:

• Enactment warm-up warm, generally the plumbum enactment 100 degree, no plumbum enactment 120 degrees
• Turning on warm-up on-off, 3 to 5 minutes
• Don't rise temperate too quickly, which results in components falling at the bottom

The fourth step:

• Using 936 iron and suck tin line clean weld plate after, smear a little liquid flux in order to spare wheel

Technical parameters:

• Working floor size: 360 x 240mm
• Rated voltage and frequency: 220 to 230V AC, 60/50Hz
• Complete machine power: 220/1,000 to 110V/1,200W
• Infrared lamp body power: 150W
• Preheating chassis power: 800W
• Infrared lamp body heating size: 70mm (50 x 50mm)
• Preheating chassis preheating size: 240 x 180mm
• Infrared lamp body temperature adjustable: 200 to 350°C
• Preheating chassis temperature adjustable: 60 to 200°C

Instrument inventory:

• Welding table main body: 1
• Infrared lamp body: 1
• Temperature sensor: 1
• Board support of the circuit: 1
• Power line: 1
• User's manual (compact disc): 1